Add Engine Oil; Add Fuel - Husqvarna 1365GN Operator's Manual

8. Remove the existing hardware from the left unit
vibration mount with 13mm wrench. Use the same
hardware to attach the support leg (E).
9. Attach other side of support leg with M8 x 20 mm cap
screw (F) and M8 lock nut (G).
10. Attach handles (H) to brackets on generator frame as
shown, with 45 mm capscrews (J), flat washers (K),
nylon washers (L), and M8 lock nuts (M).
NOTICE DO NOT overtighten. Handles must be able to
move up and down freely.
11. Return generator to normal operating position (resting
on wheels).
12. Loop handle pins (N) on generator frame just above
handle brackets.
13. Raise handles and insert handle pins to move
generator.

Add Engine Oil

• Place generator on a level surface.
NOTICE Any attempt to crank or start the engine before it
has been properly filled with the recommended oil will
result in equipment failure.
• Refer to engine manual for oil fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil
recommendations and instructions.
NOTICE Check oil often during engine break–in. Refer to
engine operator's manual for recommendations.
8

Add Fuel

NOTICE Refer to engine operator's manual and follow fuel
recommendations.
WARNING Fuel and its vapors are extremely
flammable and explosive.
Fire or explosion can cause severe burns
or death.
WHEN ADDING FUEL
• Turn generator OFF and let it cool at least 2 minutes before
removing fuel cap. Loosen cap slowly to relieve pressure in
tank.
• Fill fuel tank outdoors.
• DO NOT overfill tank. Allow space for fuel expansion.
• If fuel spills, wait until it evaporates before starting engine.
• Keep fuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
• DO NOT light a cigarette or smoke.
1. Clean area around fuel fill cap, remove cap.
2. Slowly add unleaded gasoline (A) to fuel tank (B). Be
careful not to fill above the baffle (C). This allows
adequate space for fuel expansion as shown.
C
3. Install fuel cap and let any spilled fuel evaporate before
starting engine.
B
TANK
FUEL
A
www.usa.husqvarna.com