Cwmode; Dataoperation; Fskmode; Afskmode - Kenwood TRC-80 Instruction Manual

.
CWMode
1 Selecta CWchannel.
CH
02
I I.J 1'71 171
I 1.ILl ILl
cw
)
2 Witha CWkey
connected
to the Rear Panel,
begin sending.
. Closing the keycontactscauses the
radiotelephone t o automatically s witchinto
transmitmode,and''T)(''appears.
m
$1 3 5 7 9 20 40 dB
...............
RF 2 4 6 8 10
3 Stop sending.
.
The radiotelephoneautomaticallychanges
back to the receive mode a moment after you
stop sending, and "TX" disappears.
Note:
Adjusting the DELA Y control on the Rear Panel allows
you to vary the time that the radiotelephone waits before
returning to receive mode after you stop sending. The same
control allows you to select full break-in (receiver ON
continuously except while key is down).
DATAOPERATION
I
The [DATA] button must be activated by your
Dealer to function as described here. Also, the
Dealer sets eitherAFSK or FSK operation, FSK
shift, key-down polarity,high/Iowtone, and FSK
Reverse functions for your radiotelephone.
FSKMODE
1 Selectan FSKchannel, t henpress[DATA].
. "DATA" a ppears("USB"/"LSB" disappears).
CH
03
C J
171I.J 171
n
Lt
c... ILl 1. ILl ILl
DATA
2 Followingthe instructionsprovided with your
MultimodeCommunicationsProcessor (MCP) or
TerminalUnit (TU), begin sending data.
. "TX" appears each time the radiotelephone
enters transmit mode.
m
S1 3 5 7 9 20 40 dB
...............
RF 2 -4 6 8 10
AFSKMODE
1 SelectanAFSKchannel, t henpress[DATA].
. "DATA" p lus"LSB"or "USB"is visible.
\
/
CH
o
I
I I.J I J IJ J 171171
I 1.-, 0 C. ILl ILl
USB DATA
2 Followingthe instructionsprovided with your
MultimodeCommunicationsProcessor (MCP) or
TerminalNode Controller (TNC), begin sending data.
. "TX" appears each time the radiotelephone
enters transmit mode.
\
lEt
)
I
SI 3 5 7 9 20 40 dB
...............
RF 2 4 6 8 10
9