Network Settings; Connection Settings; Ethernet Settings; Wireless Encryption - Bosch Mastertech M-VCI Installation Manual

11 | Installation Steps | Step 4
Note: The S/N shown should agree
with the S/N on the label of the
M-VCI unit.
Step 4 – Setting up your
M-VCI (Applies to Types I,
II & III) (Clearing Existing

Network Settings)

Click: Network Setup Tab
f
f Click: Clear Network Settings
f Click: OK
f Wait for the "Configuration
Complete" Message
Step 4 – Setting up your
M-VCI (Applies to Types I,
II & III) (Configuring Wired

Ethernet Settings)

While in Network Setup:
Click: Wired Ethernet Tab
f
Robert Bosch LLC M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | June 2009
f Click: Enable Wired Ethernet
Interface
Note: If your network utilizes
Static IP addresses, do not enable
Wired Interface with Static IP.
Note: This will allow M-VCI to
be connected to any network
Ethernet port if there is limited or
no wireless coverage.
Step 4 – Setting up your
M-VCI (Applies to Types I, II
& III) (Configuring Wireless

Connection Settings)

While in Network Setup:
Click: Wireless (802.11) tab
f
Click: Enable Wireless Interface
f
Click: Access Point button
f
Note: If your network utilizes
Static IP addresses, see
Appendix A.
Step 4 – Setting up your
M-VCI (Applies to Types
I, II & III) (Setting the
Wireless SSID)
Click: Refresh
f
Select: Available Network
f
– Bosch_VCI_AP
(include underscores)
f Click: Configure
Option: You can manually enter SSID
Bosch_VCI_AP into the text box.
Note: Refer to Appendix D when
dealing with a network with
multiple access points.
Step 4 – Setting up your
M-VCI (Applies to Types
I, II & III) (Setting the

Wireless Encryption)

f Verify: Network Authentication
M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | June 2009
Installation Steps | Step 4 | 12
– WPA – Personal
– TKIP
Enter: security password
f
– Bosch_VCI_800-321-4889
(include underscores)
f Click: Next
Note: Double check password:
Bosch_VCI_800-321- 4889
Step 4 – Setting up your
M-VCI (Applies to Types
I, II & III) (Verifying your
Settings)
Verify Your Settings
f
Click: Yes, Select OK
f
f Wait for the "Configuration
Complete" Message
Robert Bosch LLC