Stamping Function - Canon FY8-13FW-000DADF-A1 Service Manual

CHAPTER 2 BASIC OPERATION
H. Stamping Function
1. Outline
The machine is equipped with a stamping
function, which operates only in fax mode. The
stamping mechanism operates when memory
transmission or direct transmission is selected.
A stamp marking is put on originals in
response to a command from the copier; the
stamping solenoid (SL4) is driven to place a
spot (about 3 mm in diameter) on originals.
A marking is on the face of each original as
follows:
Mode
Single-sided original
mode
Double-sided
original mode
Reduced page
compositionmode
Table 2-206
2-40
COPYRIGHT © 1998 CANON INC.
Position
On each original
On 1st side
On each original
CANON DADF-A1 REV.0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
The stamp marking is placed as shown:
Print side
Center of the original
50 mm
(approx.)
20 mm
(approx.)
Figure 2-264
Feeding direction