EdgeMarc 4500 SOHO Router Installation Guide
Back Panel
A
Power Connector
10/100 Mbps LAN
B
Ports
C
USB Ports
D
Ethernet WAN
Port
E
Management
Console Port
Figure 2: NEC EdgeMarc 4500 Back Panel
Name
Accepts the plug from the supplied power cord to connect the unit
to an AC power source
Local Area Network (LAN) ports to connect the IP phones or an
Ethernet switch. Unit can also be configure through any of these
ports using the web interface
2 x USB ports (Not Used)
This port is typically used when connecting the EdgeMarc 4500 to
a cable or xDSL modem.
This port is used to establish a local console session with the
EdgeMarc 4500 using a VT100 terminal or emulation program.
The cable required is a straight-through 8-wire cable. The serial
port uses a baud rate of 9600, 8 data bits, 1 stop bit and no parity.
This port is used for debug or local diagnostic purposes only.
Primary configuration of the EdgeMarc 4500 is performed from a
web browser as covered in VOS User Manual
Description
5