Inspection And Confirmation After Reassembly - Hitachi N 5008AC Technical And Service Manual

(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
Insert the pointed end of the Hinge Pin [67].
Mount the Cover Spring [58] facing the longer arm side toward the Magazine Ass'y [68] as shown in Fig. 17.
Apply grease to the Shaft Ring [64] and mount it in the 8 mm (.315 ") dia. hole of the Magazine Ass'y [68]
for easy reassembly.
Be careful not to drive the Pin [59] excessively. The Pin [59] is properly driven if it is at the position 0.5 mm
(.02 ") lower than the tail cover.
Mount the Cover Spring [58] facing the
longer arm side toward the magazine.

11. INSPECTION AND CONFIRMATION AFTER REASSEMBLY

Check that Plunger (B) [45] and Trigger Plunger [51] move smoothly.
Check that there is no air leakage from each part.
While driving staples with an air pressure of 4.5 kgf/cm
bending of staples.
Recheck the tightening torque of each screw.
Check that Pushing Lever [31] slides smoothly.
Check that the machine will not operate only by actuating Trigger [52]. Also check that the machine will not
operate only by depressing Pushing Lever [31].
Flat-blade
screwdriver
Cover Spring [58]
Fig. 17
Magazine Cover [57]
Push out.
Magazine Ass'y [68]
Hinge Pin [67]
Toward the magazine
2
(63 psi), check that there is no idle driving and
--- 24 ---
Pull out.