Connecting Wires To Terminals - Kenwood DDX4028BT Installation Manual

Connecting Wires to Terminals

Bluetooth Microphone (Accessory 5)
DDX4028BT/DDX4058BT only
Antenna Cord
FM/AM antenna input (JASO)
Accessory 1
Light blue/Yellow
(Steering remote control
wire)
Blue/White
(Power control/antenna
control wire)
Brown
(Mute control wire)
Yellow (Battery wire)
Red (Ignition wire)
Red (A7)
Yellow (A4)
Connector A
Connector B
Pin Colour and functions
A4 Yellow
A5 Blue/White
A6 Orange/White
A7 Red
A8 Black
4
DDX4028BT/DDX4058BT/DDX3028/DDX3058
(Reverse sensor wire)
FUSE ( 10A )
If no connections are made, do not let the cable come out from the tab.
To use the steering wheel remote control feature, you need
to an exclusive remote adapter (not supplied) matches
your car is required.
To the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the
vehicle.
To the terminal that is grounded when either the
telephone rings or during conversation. (To connect the
Kenwood navigation system, consult your navigation
manual.)
Battery
Power Control
Dimmer
Ignition (ACC)
Earth (Ground) Connection
Connect to vehicle's reverse lamp
Purple/White
harness when using the optional rear
view camera.
Light Green
(Parking sensor wire)
For best safety, be sure to connect
the parking sensor.
⁄
Connect to the vehicle's parking
brake detection switch harness.
Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied
wiring harness as illustrated below.
Red
(Ignition wire)
Unit
Yellow
(Battery wire)
Default wiring
Pin
B1/B2 Purple+ / Purple/Black-
B3/B4 Gray+ / Gray/Black-
B5/B6 White+ / White/Black-
B7/B8 Green+ / Green/Black-
Extension cable (Accessory 2)
Red (A7)
Vehicle
Yellow (A4)
Colour and functions
Rear Speaker (Right)
Front Speaker (Right)
Front Speaker (Left)
Rear Speaker (Left)