Setting Up the AAC Audio Input,
The following displays the input type and the Web GUI input selections in
relation to the rear panel equipped with a Dual Channel Audio (DCA) card or a
Multiple Channel Audio (MCA) card:
If you select Dolby-E Decoder (Pair 1 to 4), you must set up the Dolby-E Decoder
in the Dolby-E Decoder page. For more information, see Setting up the Dolby-E
Decoder (MCA card only), page 5-85.
6. Select the Sample Rate of the signal.
Set the sampling rate to 32, 44.1 or 48 kHz.
Note: You must select 48 kHz if the Passthrough of AAC is enabled.
Note: There is no advantage to increasing the encoding sample rate above that
of the input sample rate.
Note: For the lowest audio bit rates it is often recommended to use the lowest
sample rate for best quality.
4038938 Rev A
Continued
Embedded Input in Web GUI
(Packet 1-4, Pair 1 or 2)
Dual Channel Audio (DCA) Rear Panel
Embedded Input in Web GUI
(Packet 1-4, Pair 1 or 2)
Multiple Channel Audio (MCA) Rear Panel
D9054 HDTV Encoder Intstallation and Operation Guide
Digital Input in Web GUI
Digital Input in Web GUI
(AES1 to AES4)
5-71