Gas Burners - Siemens Cooktop Operating Instructions Manual

The gas burners
Figure1
Figure 2
Ignitor
Thermocouple
3
There are indications to show which burner each control knob
operates. Figure. 1.
To light a burner, press the chosen control knob and turn it
toward the left, holding it in the maximum setting for a few
seconds until the burner is lit, then release it, and adjust to the
desired setting. If it does not light, repeat the procedure.
If the ignitor are dirty, this makes the burner harder
to light. Therefore, keep them as clean as possible. This
cleaning should be performed with a small brush, considering
that the ignitor can not withstand any sharp blows.
feature, use a lighter or a match to light the burner.
to prevent gas flow if the burners are accidentally extinguished.
Figure 2.
To turn on and activate this innovative system, proceed in
the same way, but keeping the control knob pressed down
until ignition takes place, the flame appears and does not
extinguish.
If ignition does not take place, repeat the procedure, keeping
the control knob pressed down 1-5 seconds.
To turn it off, turn the control knob to the right to the correct
position . When carrying out this procedure, the ignition
system may activate again. This is completely normal.
that make it possible to adjust to the necessary setting
between the maximum and minimum flames.
Triple flame burners are very practical and convenient for
cooking with "paella" pans, Chinese Woks (all sorts of Asian
dishes), etc.
The use of the appliance produces heat and humidity in the
site where it is installed. Ensure that the kitchen has good
ventilation. Keep ventilation channels open or install a
mechanical ventilation system (extraction hood).
Prolonged use of the appliance with several or all cooking units
may require additional ventilation, such as opening a window
(without causing air currents) or increasing the power of
mechanical ventilation if it exists.
3
11