Panasonic KX-NCP500 Networking Manual page 99

Basic Setting programming through the KX-HGT100
Follow the procedure below to program the Basic Setting parameters through the KX-HGT100.
Note
•
Before programming these settings, it is recommended to set the IP address of the KX-HGT100. For
details about setting IP addresses, refer to "For KX-HGT100 SIP Telephones" in "4.5.1 Assigning the
IP Addressing Information".
•
It is necessary to turn off, then turn on the power of the KX-HGT100 after programming settings for
changes to take effect.
To start programming
Press PROGRAM.
To configure the Telephone Number/SIP ID
Select desired parameter.
To configure the SIP Password
Select "SIP Password".
To configure the Proxy Address/Registrar Address/SIP Domain
Select desired parameter.
To configure the Proxy Port/Registrar Port
Select desired parameter.
To end programming
Press PROGRAM.
Document Version 2010-08
Hold INFORMATION for 3 seconds
while "Save speed dial?" is displayed.
Extension No.
Press OK.
SIP Password
Press OK.
Enter the IP address of
Press OK.
the MPR card.
Press OK.
4.6.1 Registering IP Telephones
Max. 5 digits Press OK.
Max. 16 digits Press OK.
IP Address
Press OK.
Port No.
1–65535 Press OK.
IP Networking Guide 99