Burners; Controls; Dual-Flame Stacked Burners - GE 36” Owner's Manual

Electronic
The rangetop is equipped with electronic ignition
which eliminates the need for a standing pilot
ignition &
light.
automatic
The burners will automatically relight if the flame
reignition
goes out.
All surface burner igniters will spark and make
clicking sounds when any burner is turned on.
Do not touch any of the burners when igniters
are clicking.
Occasionally the burners may spark if excess
wind or a draft blows the flame away from the
burner's flame sensor.
To light
Push the control knob in and turn it
a surface
burner
Dual-flame
stacked

burners

to the
All surface burners have two sets of flames
stacked one on top of the other; the dual-flame
burners have a lower (simmer) flame and a
upper (main) flame.
When a burner is turned on, the lower flame
will always light and stay on.
The stacked burner design provides a wide
rangetop of heat settings with which to simmer.
Depending on the type and quantity of food,
and pan size, the flame can be adjusted to suit
your specific need. The lowest setting uses only
the lower flame and can maintain delicate foods
at a safe 140°F.
Settings from to I will use both upper
and lower flames. Use
cooking. Use or (highest setting) with
larger diameter cookware.
Rangetop Controls
The griddle and IR (infrared) grill are equipped
with Glo-Bar igniters. The Glo-Bar remains
energized whenever the griddle or IR grill is in
use to ensure the burner always stays lit.
surface burners on your rangetop with a match.
Hold a lighted match to the burner, then turn the
knob to the LOW position.
Do not attempt to light the grill or griddle during
a power outage. The gas to these burners will
automatically shut off during a power outage.
position. the flame size.
as far as it will go, to the
• Do not operate a burner for an extended
ON
Indicator
Light
• The indicator light on each bezel verifies the
to for all purpose
Professional Rangetops
turn the knob to adjust
turn the knob clockwise,
period of time without cookware on the grate.
The finish on the grate may chip without
cookware to absorb the heat.
burner is on. However, it should not be a
substitute for visually checking the flame at the
burner.
and are very high heat settings and
are intended to sear foods quickly and boil
large quantities of water.
you can light the
position.
Lower
Flame
Upper
Flame
Lower Flame
9