Chapter 2 Getting Started; Battery Installation; Ac/Dc Adapter Connection; Important Safety Warnings - Silvercrest Laptop User Manual

Chapter 2
Chapter
Getting Started
Your SilverCrest Laptop operates on 3 AA-size batteries
or a 6V AC/DC adapter.

Battery Installation

1. Make sure the unit is turned off.
2. Using a coin, open the battery cover
at the back of the unit.
3. Insert 3 AA-size batteries.
(Note the correct polarity: +, - ).
4. Replace the cover.

AC/DC Adapter Connection

Please turn off the unit before plugging
in the AC/DC adapter. Otherwise the
unit may be damaged.
Slide back the adapter cable at the rear
of the unit and plug the AC/DC adapter
into the the socket (center positive type).
CD50 manual_UK.indd 3
2

Important Safety Warnings

Caution
• Do not mix different types of batteries or old and new batteries.
• Only use batteries of the same or equivalent type
as recommended.
• Remove all batteries when replacing.
• Remove batteries from the unit if the unit is not
going to be used for long periods of time.
• Do not dispose of batteries in fire.
• Do not recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy
before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Remove exhausted batteries from the toy.
• Do not short-circuit the supply terminals.
• Batteries must always be inserted with the correct polarity (+ or -).
• Batteries should only be installed by an adult.
• Do not dispose of exhausted batteries with the household rubbish.
Take them to a hazardous waste depot. Help to protect the
environment!
Caution
• The unit must not be connected to a power supply greater than 6V.
• Only use the recommended adapter.
• The adapter is not a toy.
• Do not short-circuit the supply terminals.
• Toys should be disconnected from the power source before
cleaning.
• Due to AC/DC Adapter Connection - Not suitable for children
under 3 years, and must be operated under adult supervision.
• In an environment prone to static discharge, the unit
may malfunction.
• To reset, remove batteries or disconnecting the adaptor
for at least 10 seconds before connecting the power supply again.
3
8/3/09 4:11:23 PM