All rights reserved. No part of this publication may by reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronics, mechanical, photocopying, or otherwise without the prior permission of Philips 3141 785 30710 Version 1.0...
3.48V~3.53V adapter. Force Power Off voltage <3.5V Make sure all other applications such as Philips Device plug-in, Windows Media Player or Windows Explorer that accessing the device are closed or Current consumption else Device Manager will not recognize the device.
Page 3
Once the installation is complete, connect the GoGear to the power supply with the AC/DC adapter. Make sure all other applications such as Philips Device plug-in, Windows Media Player or Windows Explorer that accessing the device are closed or else Device Manager will not recognize the device.
Volume + and the power on/off slider switch until the display turns off. While the device restart, press and hold the volume – key until the Philips splash screen disappear and showing the connection icon to put the device in USB Mass Storage Device mode.
Page 5
1.0 TECHNICAL SPECIFICATION and SERVICE HINTS Launch Windows Explorer and then quick format drive file system FAT32 IMPORTANT: All music & content of your micro jukebox will be erased once the device is formatted. Unzip and copy all the content of the shipment ui files of the corresponding model version into the root directory of the device.
Page 6
2.0 SAFTETY INSTRUCTIONS WAARSCHUWING WARNING Alle IC’s en vele andere halfgeleiders zijn All ICs and many other semi-conductors are gevoelig voor electrostatische ontladingen susceptible to electrostatic discharges (ESD). (ESD). Careless handling during repair can reduce life Onzorgvuldig behandelen tijdens reparatie kan drastically.
4.0 MECHANICAL INTRUCTIONS Set Disassembly 1. Remove 2 screws at the bottom by screwdriver. 2. Use finger nail or screwdriver to carefully lift up the back cover of the device. 3. Gently open up the back cover. 4. Remove the volume button.
Page 9
4.0 MECHANICAL INTRUCTIONS 5. Remove the 6 screws on two sides. 6. See pointed arrow. There are 2 screws at the bottom side and 4 screws at the top side. 7. Open up and remove the bottom part. 8. Disconnect the flex cable from the front touch screen module carefully.
Page 10
4.0 MECHANICAL INTRUCTIONS 9. Turn to the back. 10. Open up the shielding carefully. 11. Be careful on the L-shape PCBA / LCD module. 12. Disconnect the flex cable of battery part from PCBA module.
Page 11
4.0 MECHANICAL INTRUCTIONS 13. Disconnect the flex cable of hard disk from PCBA module. 14. Remove the PCBA module. 15. Separate the battery from the hard disk.