Bosch DCN Next Generation Installation And Operation Manual page 146

146 en | Connection
12. Make sure that the Strain Relief (B)/Plastic Enclosure (C) assembly is locked to the Top
13. Align the new assembly with the Plastic Coupling (I) shown in the drawing. Push
For more information refer to Section 7.17 PRS-NSP Network Splitter.
6.25 PRS-FINNA Fiber Interface
Optical network
The fiber interfaces connects a POF to a GOF. Use a GOF to connect two pieces of equipment
in the optical network that are more than 50 m apart and less than 1,500 m. Use the fiber
interfaces as a pair. The first connects a POF to a GOF, the second connects the GOF to a
POF.
Figure 6.52 Optical network
NOTICE!
If the distance between two devices is less than 100 m, a network splitter can be used in the
middle to remove the use of fiber interfaces. Use only the trunk sockets of the network splitter
in this case.
The GOF socket is a double SC socket that uses invisible infra-red light (1300 nm).
Figure 6.53 Double SC socket, connection
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
Make sure that the Metal Spring (D) stays in place and does not bend during assembly. A
large force can be necessary to attach the two assemblies together.
Metal Cover (F)/Lower Metal Sleeve (H) assembly. The two assemblies should not be
able to be pulled apart.
assembly into Plastic Coupling (I) until it locks to the Plastic Coupling. The connector
assembly is complete.
POF
2
5 5
GOF ( > 50m)
Tx Rx
Installation and Operation manual
POF
2
Conference System
Bosch Security Systems B.V.