CHECKING THE BRAKE FLUID LEVEL/
CHECKING THE FRONT BRAKE PADS
a
• Refill with the same type of brake fluid
that is already in the system. Mixing
brake fluids may result in a harmful
chemical reaction, leading to poor brake
performance.
• When refilling, be careful that water does
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor
lock.
CAUTION:
_
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.
NOTE:
_
In order to ensure a correct reading of the
brake fluid level, make sure that the top of the
brake master cylinder reservoir is horizontal.
EBS00088
CHECKING THE FRONT BRAKE PADS
1. Remove:
• front wheels
Refer to "FRONT AND REAR WHEELS" in
chapter 8.
2. Check:
• brake pads
Wear indicator groove a almost disap-
peared → Replace the brake pads as a set.
Refer to "FRONT AND REAR BRAKES" in
chapter 8.
Brake pad wear limit a
1.0 mm (0.04 in)
3. Operate the brake lever.
4. Install:
• front wheels
Refer to "FRONT AND REAR WHEELS" in
chapter 8.
3 - 47
CHK
ADJ