Tools And Materials Required; Electrical Requirements; Unpacking Your Dryer; Exhaust System Connections - Haier CGDE480BW Service Manual

Service Manual
Model No. CGDE480BW
7 Key points in installation, adjustment and disassembly
Select a suitable location for the dryer on a hard even surface away from direct sunlight or heat
source e.g. Radiators, baseboard heaters, cooking appliances etc . Any floor unevenness
should be corrected with leveling legs located on the bottom of the dryer.

Tools and materials required

Phillips head and flathead screwdrivers
Channel-lock adjustable pliers
1 2 inch open end wrench
'
Carpenter s level

Electrical requirements

Power supply:
Power supply cord kit:
(Not supplied when sold in the United States) the dryer MUST employ a 3-conductor power supply cord NEMA
10-30 type SRDT rated at 120 Volt AC minimum, 30 Amp, with 3 open end spade lug connectors with upturned
ends or closed loop connectors and marked for use with clothes dryer.
C

Unpacking your dryer

1) remove all packaging material . This includes the foam base and all adhensive tape holding the dryer
acessories inside and outside.
2) inspect and remove any remains of packing, tape or printed material before using the dryer.
C

Exhaust system connections

C
Materials
Use only 4 inch (10.2.cm) diameter (minimum) rigid or flexible
metal duct and approved vent hood which has a swing-out damper
hat open when the dryer is in operation . When the dryer stops, the
dampers automatically close to prevent drafts and the entrance of
insects and rodents . To avoid restricting the outlet, maintain a
minium of 12 inches ( 30.5 cm) clearance between the vent hood
and the ground or any other obstruction . The vent flap should be able to remove freely.
0
1
2
3
4
Measuring tape ( 12ft.min.)
Duct tape
Rigid or flexible metal 4 inch ( 10.2 cm) duct
Vent hood
3 wire , 120 volt , 30 amp, 60Hz, 1 phase
INSTALL MALE FITTINGS IN CORRECT DIRECTION
CORRECT
of 4''(10.2cm)Dia.Flexible Metal Duct
Number
of
90
turns
4''
(10.2 cm)
0
30ft. (9.14 m)
1
22ft. (6.71 m)
2
14ft. (4.27 m)
9 6
Issue
Rev.
INCORRECT
MAXIMUM LENGTH
VENT HOOD TYPE
(Preferred)
Louvered
21/2''
(6.35 cm)
18ft.(5.49 m)
14ft.(4.27 m)
10ft.(3.05 m)