Configuring Your Remote Control - JVC 0509SKH-SW-MT Instructions Manual

Configuring your remote control

You can configure your monitor's remote control to operate your
other devices.
Configure your remote control.
1
Turn on the device manually.
2
Switch the remote control mode to a mode that
matches your device. Refer to the table below to
select an appropriate mode.
The indicator lights for 3 seconds each time the remote
control is operated.
3
Find the remote control code for your JVC device
from the table below.
MODE
TV
STB
DVD
AUDIO
LCD
TV
AUDIO
Applicable devices Remote control codes
This monitor only
Not in use
DVD 0503, 0539, 0623, 1241, 1550,
1602, 1701, 1860, 1863, 1940
DVD/DVD-R 1164, 1275, 1597
Home Theater in Box 0623, 1701, 1860, 1863, 1940
Receiver/Home 0074,1374,1676, 2000, 2001
Theater in Box
4
Set the remote control code.
Press and hold
5
Point the remote control at your device, press
and confirm that your device is turned off. If your
STB
device does not respond, try entering another
available code.
DVD
Note
If none of the code works, refer to "Using the search code
function" (P. 16).
Release the button
Enter four digit
number
15