Remote Control; Remote Control Basics; Changing The Batteries - JVC AV 27260 User Manual

RM-C305
TV CATV VCR DVD
PIP
CHANNEL ON/MOVE
SOURCE FREEZE SWAP
VIDEO STATUS 1 2
4 5
DISPLAY 7 8
0
100+
SLEEP TIMER
HYPER SURROUND
RM-C305
MUTING
+
CH
VOL
VOL
+
C H
MENU
VCR/DVD
VCR CHANNEL
POWER
PREV NEXT
REW PLAY
STOP PAUSE
REC
OPEN/CLOSE STILL/PAUSE
TV

Changing the Batteries

Push down on the remote's back cover and slide towards the bottom to remove it.
Insert two AA batteries (supplied), carefully noting the "+" and "-" markings on the batteries and on
the remote control. To avoid a potential short circuit, insert the "-" end first. Be sure to use only size
AA batteries.
When batteries are installed, slide the cover back into place (until it clicks into position).
• If the remote control acts erratically, replace the batteries. Typical battery life is six months to one
year. We recommend using alkaline batteries for longer battery life.
When you change the batteries, try to complete the task within three minutes. If you take longer than three
minutes, the remote control codes for your VCR, DVD, and/or Cable Box may have to be reset (see page 18-20).

Remote Control Basics

•
Before you can operate the remote control, you must first install
POWER
the batteries (included). See "Changing the Batteries" at the
bottom of this page for instructions. (For an illustration, please see
page 7.)
INPUT
•
Press the P
3
•
Make sure the TV/CATV switch is set to TV. Move the switch to
CATV only if you need to operate a cable box.
6
•
Slide the VCR/DVD selector switch to VCR to control a VCR,
9
slide to DVD to control a DVD player. Please see pages 18 to
20 for instructions on programming your remote control to
RETURN+
operate a Cable box, VCR or DVD player.
•
Press the CH+ and CH- buttons to scan through the channels.
Tap the CH+ or CH- button to move through the channels one
channel at a time.
V CHIP
•
To move rapidly through the channels using JVC's Hyperscan
feature, press and hold CH+ or CH-. The channels will zip by at
a rate of five channels per second.
EXIT
•
Press V
PIP OFF
bar will appear onscreen to show you the television volume
TV/VCR level.
•
The CH+/- and V
FF
onscreen menu system.
•
You can directly access specific channels using the 10-key pad.
•
For more information on remote control button features, see
pages 40 to 45. For information on using the onscreen menus,
see page 21.
Notes: Remote control model RM-C305 is shown at the left.
A different model remote control may have come with your
television.

Remote Control

button to turn the television on or off.
OWER
+ or V - to raise or lower the volume. An indicator
OL OL
+/- buttons are also used to navigate JVC's
OL
17