Table of Contents
Advertisement
(;
()
,;
--
Table 3. Control Cable Parts List
Step 1. Assemble the control cable as illustrated in
Figure 10and as directed in Figure 11.
Step 2.
Insert the completed I5-pin plug into the
antenna tuner connector of the TRITON radio.
Step 3.
Route the other end (solder lugs) of the control
cable through the vessel to the antenna tuner.
.
For a detailed
parts breakdown
of the TRN4423A
Connector
Kit,
see PEPS-30lOS. at the rear of this manual.
3-GONDUCTOR
CONTROL
CABLE
IS-PIN
CONNECTOR
MAIN
BRACKET
CABLE
RETAINER
I
',~
~
'~~
,.
-J
.LREW
10F'
1 OF 3 CONNECTIONS
SHOWN
WIRE
EYELET
I-~/I
(31
SOLDER LUGS
GBEPS-30047-0
Figure 10. Control Cable Assembly
STEP 1:
STRIP INSULATION
11< S OLDER LUG
TO EACH CONTROL
WIRE.
STEP 2:
FEED CONTROL
CABLE THROUGH
HOLE IN MAIN
BRACKET.
STEP S:
SLI DE HEAT
SHRINKABLE
TUBING
OVER ASSEMBLY
11< S HRINK.
STEP 3:
STRJP In"
OFF
OUTER JACKET.
STRIP INSULATION
BACK II'" ON EACH WIRE.
STEP .:
ATTACH EACH
CONTROL WI RIOTO
CHOKE-PIN
ASSEMBLY
THROUGH AN EYELET
AND SOLDER.
~
~;::~EACH
CONTROL WIRE WITH
CHOKE-PIN
ASSEMBLY
INTO ANTENNA TUNE
---
Q
CONNECTOR.
REFER TO
FIGURE.
FOR CORRECT
CONNECTIONS.
CONNECTOR
MATING
SERRATIONS
DOWN
~
~
STEP B:
PULL CONTROL CABLE
BACK INTO MAIN
BRACKET SOTIE-WRAP
IS FLUSH WITH
BRACKET OPENING.
ATTACH STRAIN RELIEF
OVER TIE-WRAP AND
SNAP CABLE 11< S TRAIN
RELIEF INTO BRACKET.
,
'
P
S TEP 9:
LOCK SIDE BRACKETS TO
CONNECTOR
TABS
AND INSERT SCREWS SECURING SIDE
BRACKETS TO MAIN BRACKET.
GBEPS-30070-0
STEP 7:
ATTACHTJE-WRAP
1/B'" FROM
OUTER JACKET EDGE.
Figure 11. Control Cable Assembly Procedure
5
Advertisement
Table of Contents
