How To Load A Ribbon And Coupon Stock; Opening & Closing The Printer Door; Replacing The Ribbon; Installing Coupon Stock - Fujitsu 9811 ATB Operator's Manual

How to load a ribbon and coupon stock

1. Opening and Closing the printer door (Cover)
To release, pull up the two lock levers and open the cover. After closing the door remember to lock by pushing down the
levers.
Lock levers

2. Replacing the ribbon

When Ribbon End message appears, please replace the ribbon cassette.
1. Turn the clamp to release the ribbon.
2. Pull out the old ribbon.
3. Take up the slack in the ribbon tape by turning the bobbin in the direction of the arrow.
4. Slide in the Ribbon Cassette on the rail and put Ribbon Tape under the print head.
Turn the clamp to fit the hollow on the cassette in order to lock the ribbon.

3. Installing coupon stock

Green coupons are placed in the Center Bin 3 and Rear Bin 1. The Blank coupon is placed in the Front Bin2.
Please lead the Green coupon in the rear bin into the Top Slot of the printer
The Green coupons in the center bin are led into the middle slot on the printer.
The Blank coupon in the front bin is led into the bottom slot.
The printer feeds the coupon automatically by detecting the inserted coupons.
Blank
Coupon
(Bin 2)

4. To switch print mode between "Direct thermal print" and "Thermal transfer (with ribbon) print"

- To change the mode to thermal transfer (with Ribbon)
1) Power off printer.
2) Load a ribbon and power on.
When you can see the message
3)
-To change the mode to direct thermal printing
1) Power off printer.
2) Removes ribbon and then power on.
3) When you can see the following message

5. Ready to accept

Printer is on ready to accept data from a server when the LCD displays a message " Ready to accept"
approximately 30 seconds after turning the power on.
1
3
2
Green Green
Coupon Coupon
( Bin 3 ) ( Bin 1
Remove ribbon
or press RST
Lead of ribbon
Green coupon to Bin1
Green coupon to Bin 3
Blank coupon to Bin2
on the panel, please push the RST key without removing the ribbon.
Install ribbon
or press RST on the panel, push RST key without installing a ribbon.
2
Operating the Printer
Printer door
Rear side of the printer