Advertisement
ICE MAKER INSTALLATION INSTRUCTIONS
NOTE
It requires the use of both hands to hook up and secure the Ice Maker to the freezer wall. DO NOT let
the Ice Maker dangle free after the wiring harness is plugged into the connector on the back freezer
wall.
6. Connect wiring harness into connector mounted on back freezer panel, just to the left of where the water inlet
tube comes through. See Figure 3. The harness connector is keyed so it will only fit one way. Then, mount
Ice Maker to the two screws (3) you started earlier from Step 5. (See Figure 4.) Tighten screws. Make sure
water inlet tube is setting inside fill cup.
7. Adjust leveling bracket (5) on Ice Maker (1). See Figure 5. When the gap between freezer wall and Ice Maker
is the same at top and bottom, then Ice Maker is level. Tighten screw (4) when level.
8. Reinstall freezer shelf in lower position. Set ice container (2) on shelf. See Figure 5.
Wiring Harness
Connector
figure 4
figure 3
Screw (3)
Fill Tube
3
figure 5
Advertisement
