JVC D-ILA LD-HD2KBU Instructions Manual page 28

Adjustments and Settings Using Menus (continued)
C
Display Menu
The Display menu will not function if SET: 1080i TO
1080p is set to HIGH BANDWIDTH MODE .
Input
Picture
Position
Horizontal
Vertical
Border Lvl
Left
Bottom
Position
.................................................................................................
Horizontal
Does not function on this processor.
.................................................................................................
Vertical
Does not function on this processor.
.................................................................................................
Border Lvl
Adjusts the blanking level (border level) from black to
white. When using a 4:3 source on a 16:9 screen, black
bars will appear on the left and right of the image. Adjust
these bars to gray color.
Setting Values: 0-100
Default Value: 0
.................................................................................................
Left
Adjusts the blanking level at the left edge.
The setting value will be displayed on the LCD.
Setting Values: 0-100
Default Value: 0
.................................................................................................
Right
Adjusts the blanking level at the right edge.
The setting value will be displayed on the LCD.
Setting Values: 0-100
Default Value: 100
28
Display Patterns
39
0
0
Right
Top
.................................................................................................
Bottom
Adjusts the blanking level at the bottom edge. The setting
value will be displayed on the LCD.
Setting Values: 0-100
Default Value: 0
.................................................................................................
Top
Adjusts the blanking level at the top edge. The setting
value will be displayed on the LCD.
Setting Values: 0-100
Default Value: 100
D
Patterns Menu
The test pattern in this unit. Used for image adjustment,
etc. It is not possible to adjust the test pattern itself.
Input Picture
Test Pattern
Select
.................................................................................................
Test Pattern
Sets whether to use the test pattern in this unit or not.
Setting Values: Off, On
Default Value: Off
.................................................................................................
Select
Selects the test pattern to output.
Setting Values:
Color Bars, Pluge, Window, Multiburst, Border,
Converge, Blue, Red, Green, Black, Cr Ramp, Cb
Ramp, Y Ramp, Grey Step, Rev Bars
Default Value: Color Bars
Display Patterns
Off
Color Bars