Table of Contents
Advertisement
TROUBLESHOOTING
92
EN
Automatic Satellite Programme Recording does not start.
●
The satellite receiver is not connected properly to this unit.
N Connect the satellite receiver to the [L-2 IN/DECODER]
connector properly. (A pg. 53)
On the front display panel, A– –:– –B appears.
●
Power failure occurred.
N Set date and time correctly. (A pg. 86)
APROGRAMME FULLB appears on the TV screen during timer
programming.
●
32 programmes have already been timer programmed.
N Clear unnecessary programmes on the unit, then try timer
programming again. (A pg. 52)
The disc space does not increase when recorded titles are
cleared.
●
The PC's data recorded on a DVD-RAM drive cannot be
cleared on this unit.
N Format the disc. (When the disc is soiled, wipe the disc with a
soft dry cloth before formatting.) (A pg. 9, 87)
Timer Recording (VHS Deck)
Timer programming cannot be made.
●
Date and time is not correct.
N Set date and time correctly. (A pg. 86)
●
The timer is not engaged.
N Press VHSj and confirm that the VHS timer indicator lights up
on the front display panel.
●
Timer recording is in progress.
N Timer programming can't be performed while a timer recording
is in progress. Wait until it finishes.
Timer programming recording does not start.
●
Date and time is not correct.
N Set date and time correctly. (A pg. 86)
●
The timer is not engaged.
N Press VHSj and confirm that the VHS timer indicator lights up
on the front display panel.
The VHS recording lamp on the unit won't stop blinking.
●
The timer is engaged but there's no cassette loaded.
N Load a cassette with the record safety tab intact.
●
The loaded cassette has had its record safety tab removed.
N Remove the cassette and cover the hole with adhesive tape, or
insert a cassette with the record safety tab intact.
a
Timer Programming cannot be made.
●
Date and time set on the unit is not correct.
N Set date and time correctly. (A pg. 86)
●
The channel position does not correspond to that in the
receiving area.
N Set the correct channel position for the receiving broadcast.
(A pg. 83)
a
The
system does not timer-record properly.
●
The unit's channel positions have been set incorrectly.
N Refer to Ac System SetupB (A pg. 83) and re-perform the
procedure.
Other Problems
The image of the TV broadcast appears distorted on the TV
screen.
For basic connection
N Press PROGRESSIVE SCAN for 3 or more seconds so that the
Video output indicator (q) lights off on the front display panel.
For component video connection
N Press PROGRESSIVE SCAN for 3 or more seconds so that the
Video output indicator (q) lights up on the front display panel.
Whistling or howling is heard from the TV during camcorder
recording.
●
The camcorder's microphone is too close to the TV.
N Position the camcorder so its microphone is away from the TV.
●
The TV's volume is too high.
N Turn the TV's volume down.
When scanning channels, some of them are skipped over.
●
Those channels have been designated to be skipped.
N If you need the skipped channels, restore them. (A pg. 84)
The channel cannot be changed.
●
Recording or RetroActive recording* is in progress.
N Press W to pause recording, change the channel, then press I
to resume recording.
* HDD deck only
Channel settings that were made manually seem to have
changed or disappeared.
●
After the manual settings were made, Auto Channel Set was
performed.
N Perform AClock SetB (A pg. 86).
Malfunction occurs and the unit cannot be power off.
N Reset the unit by disconnecting the AC power plug from the AC
outlet and connect again.
Advertisement
Table of Contents
