Siemens HiPath 3000 Opearting Instructions page 71

Step by Step
• Leave an advisory message,
69/#69 Æ page 65
code:
*
• Group ringing, code:
• Group call, code:
• Suppress caller ID,
86/#86 Æ page 26
code:
*
• Waiting tone, code:
• Open door, code:
• Door opener on/off, code:
• Control relay, code:
• Do not disturb, code:
• Ringer cutoff function, code:
• Speed-dialing, code:
• Associated service, code:
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
D
Set up a call to the system. Enter the station number
(contact the service personnel).
D
Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
G
Enter the code (necessary only if programmed in the
system).
D
Wait for a dial tone and then enter the code, such as
97 for Do not disturb on. Make other inputs as neces-
*
sary; (refer to the operating instructions for pulse and
DTMF telephones).
or
D
Dial the external number.
You can only execute one function at a time, or
set up only one outgoing connection.
The connection is immediately released after
successful activation of a function.
In the case of an external-external call, the con-
nection is released as soon as either of the par-
ties ends the call.
Using Other Functions
81/#81 Æ page 84
*
85/#85 Æ page 84
*
87/#87 Æ page 15
*
61 Æ page 21
*
89/#89 Æ page 22
*
90/#90 Æ page 74
*
97/#97 Æ page 19
*
98/#98 Æ page 19
*
7 Æ page 41
*
83 Æ page 69
*
71