Connecting The Fm And Am (Mw) Antennas - JVC LVT1112-001A Instructions Manual

Connecting the FM and AM (MW) antennas

If FM reception is poor, connect
outdoor FM antenna (not supplied).
1 2
FM antenna (supplied)
AM (MW) antenna connection
Connect the AM (MW) loop antenna supplied to the AM LOOP
terminals.
Connect the white cord to the AM EXT terminal, and the black cord to
H terminal.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-covered
wire (not supplied) to the AM EXT terminal. Keep the AM (MW) loop
antenna connected.
FM antenna connection
Connect the FM antenna supplied to the FM 75 Ω COAXIAL terminal
as temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna (not
supplied). Before attaching a 75 Ω coaxial cable with a connector
(IEC or DIN 45325), disconnect the supplied FM antenna.
If AM (MW) reception is poor, connect an outdoor single
vinyl-covered wire (not supplied).
3
Snap the tabs on the loop
into the slots of the base to
assemble the AM (MW) loop
antenna.
FM 75
COAXIAL
AM EXT
FM 75
AM LOOP
VR
ANTENNA
COAXIAL
AM EXT AUDIO
CENTER
L L
DVD
R R
DVD
SUB
SURR
IN FRONT
WOOFER (REAR)
NOTES
• If the AM (MW) loop antenna wire is covered with
vinyl, remove the vinyl while twisting it as shown on
the right.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
AM (MW) loop
antenna (supplied)
AM LOOP
ANTENNA
TV
AV IN / OUT DIGITAL 1
(VR)
DIGITAL 3 DIGITAL 2
DIGITAL IN
(DVD) (STB)
STB
AV IN
CAUTION:
SPEAKER
SUBWOOFER IMPEDANCE
OUT 8 ~ 16
Getting started
CENTER SURROUND FRONT
SPEAKER SPEAKERS SPEAKERS
RIGHT LEFT RIGHT LEFT
5