Connecting The Fm And Am (Mw) Antennas - JVC RX-ES9SL Instructions Manual

Connecting the FM and AM (MW) antennas

If FM reception is poor, connect
outdoor FM antenna (not supplied).
1
FM antenna (supplied)
AM (MW) antenna connection
Connect the AM (MW) loop antenna supplied to the AM LOOP
terminals.
Connect the white cord to the AM EXT terminal, and the black cord to
H terminal.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-covered
wire (not supplied) to the AM EXT terminal. Keep the AM (MW) loop
antenna connected.
FM antenna connection
Connect the FM antenna supplied to the FM 75 Ω COAXIAL terminal
as temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna (not
supplied). Before attaching a 75 Ω coaxial cable with a connector
(IEC or DIN 45325), disconnect the supplied FM antenna.
01-10_RX-ES9SL[B]f
2 3
FM 75
COAXIAL
FM 75
AM LOOP
ANTENNA
COAXIAL
AM EXT
CENTER
L
R
DVD
SUB
IN FRONT
WOOFER
5
If AM (MW) reception is poor, connect an outdoor single
vinyl-covered wire (not supplied).
Snap the tabs on the loop
into the slots of the base to
assemble the AM (MW) loop
antenna.
AM LOOP
ANTENNA
AM EXT
VR TV
AV IN / OUT
AUDIO
DIGITAL 3
L
DVD STB
AV IN
R
SURR
(REAR)
NOTES
• If the AM (MW) loop antenna wire is covered with
vinyl, remove the vinyl while twisting it as shown on
the right.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
03.6.27, 16:45
Getting started
AM (MW) loop
antenna (supplied)
CENTER SURROUND FRONT
DIGITAL 1
SPEAKER SPEAKERS SPEAKERS
(VR)
RIGHT LEFT RIGHT LEFT
DIGITAL 2
DIGITAL IN
(DVD) (STB)
CAUTION:
SPEAKER
SUBWOOFER IMPEDANCE
8 ~ 16
OUT
5