Table of Contents
Advertisement
SE3401 | Installation Instructions |
3. Be sure to note the location of the magnet when
mounting the base.
4. Slide the point transmitter over the base to lock it
into place as shown is Figure 3.
Figure 3: Slide Point Transmitter Over Base
5. The point transmitter can be released from the base
by pressing the release tab with a small screwdriver
or a paper clip.
6. For higher security installations, mount the
transmitter using the tamper screw provided (see
Figure 4).
Figure 4: Mount Transmitter Using Tamper Screw
1 - Tamper screw
Bosch Security Systems | 6/03 | 40281E
3.0 Mounting the Point Transmitter
1
3.2
Mounting Without the Mounting Plate
1. If the battery was installed in the point transmitter,
remove it at this time.
2. Using a small screwdriver, gently lift the printed
circuit board away from the case mounting clips.
You do not need to remove the cover to remove the
board.
Figure 5: Lift Printed Circuit Board
3. Rock the board gently to loosen the battery clips
from the case and slide the board away from the
mounting clips near the area where the cover
connects to the base.
4. Mount the point transmitter in the desired location,
taking note the magnet needs to be on the same side
of the case as the reed switch.
Figure 6: Mount Point Transmitter in Desired
Location
1 - Magnet side
2 - Mounting holes
EN | 3
1
2
Advertisement
Table of Contents
