Clean-Up Tips; How To Store; Normal Wear - Pioneer Brite Striper 2000 Instruction Manual & Parts List

CLEAN UP TIPS
All parts of your PIONEER Brite Striper
after each use. We recommend Pioneer P.H.D. Cleaner. A clean, lint-free rag
should be used to wipe dry the inside of the tank.
A final step should then be to remove the nozzle caps and clean the nozzle tips
and screens. This can easily be done by placing all three parts into a small can of
soapy water and allowing them to soak for a few minutes. An old toothbrush can
be used for stubborn spots. Rinse Nozzle Assembly parts with clean water and
allow to air dry. Do not store with pump locked in tank, leave loose.
CAUTION: DO NOT USE WIRE OR ANY OTHER OBJECT TO CLEAN NOZZLE TIP AS
THIS MAY CAUSE TIP ORIFICE TO BECOME ENLARGED WHICH WILL RESULT IN
POOR PERFORMANCE WHEN STRIPING.

HOW TO STORE

Cleaning your machine thoroughly cannot be overemphasized. A little
extra effort at the end of each job will save you time and money when
it is time to stripe again. As stated previously, run a tankful of water
through the machine. Be sure to clean out screen inside the Nozzle As-
sembly.
IMPORTANT: BE SURE TO CLEAN PUMP UNIT IN TANK. IMMERSE IN CLEANING SO-
LUTION AND PUMP SEVERAL TIMES. FAILURE TO DO THIS MAY RESULT IN LEAKS
OR MALFUNCTION IN THE UNIT.
When storing your striper for an extended period, do the following:
1. Flush machine out thoroughly.
2. Remove hoses and drain.
3. Run engine until gas tank is empty.
4. Wipe the sides and bottom of the inside of the tank
with a clean dry rag.
5. Lubricate spray valve (shut-off valve).
6. Apply vaseline or similar substance to pump gasket.
7. Do not store with pump assembly tight.

NORMAL WEAR

Warranty will not cover repair where normal use has exhausted the
life of the part. Line stripers, like all mechanical devices, need periodic
parts replacement and service to perform well. It should be remembered
that the service life of any equipment is dependent on the care it
receives and the conditions under which it has to operate.
REV 2/08
®
2000 should be cleaned immediately
11