Technical Specification - Philips VR120 Service Manual

List of PWBs, Features, Technical specifications
1.3

Technical specification

Mains voltage
Mains frequency
Power consumption
without Low Power Standby
with Low Power Standby
Ambient temperature
Relative humidity
Dimensions
Weight
Fast forward/rewind time (turbo)
Position of use
Video resolution
Audio SP: Linear Audio
Audio LP: Linear Audio
Stereo FM Audio
Euroconnector (AV1) SCART plug 1
Connection to TV, monitor, projection TV ...
Pin 1 ARO (audio right out) 500 mV
Pin 2 ARI (audio right in)
Pin 3 ALO (audio left out)
Pin 6 ALI (audio left in)
Pin 7 Blue (out) **)
Pin 8 Switching output:
Pin 11 Green (out) **)
Pin 15 Red (out) **)
Pin 16 Blanking (out) **)
Pin 19 CVBS II (video out)
Pin 20 CVBS I (video in)
**) passive loop through from AV2
Euroconnector (AV2) SCART plug 2
Connection to decoder, SAT tuner, video disc, 2nd VCR ...
Pin 1 ARO (audio right out) 500 mV
Pin 2 ARI (audio right in)
Pin 3 ALO (audio left out)
Pin 6 ALI (audio left in)
Pin 7 Blue (out) **)
Pin 8 Switching input only:
Pin 11 Green (in) *)
Pin 15 Red (in) *)
Pin 16 Blanking (in) *)
Pin 19 CVBS II (video out)
Pin 20 CVBS I (video in)
*) passive loop through to Euroconnector AV1
: 220 - 240 V, +/- 10%
: 45 - 65 Hz
: mono 12.5 W during
operation
: HiFi 16 W during
operation
: mono 4 W during
standby
: HiFi 4.4 W during
standby
: < 4 W standby
: +10°C to +35°C
: 20 - 80 %
: 380 x 260 x 94 mm
: 3,7 kg
: typ. 100s (E180
cass.)
: horizontally, max.
15°
: ≥240 lines
: 80Hz - 10kHz (±6
dB)
: 80Hz - 5kHz (±6
dB)
: 20Hz - 20kHz
(±3dB)
+/- 3 dB R 1 kOhm
rms out
0,2 V to 2V R 10 kOhm
rms rms in
500 mV +/- 3 dB R 1 kOhm
rms out
0,2 V to 2 V R 10 kOhm
rms rms in
(with R = 10kOhm, C <2nF)
load load
low: 2 V
high: 9.5 V
rise time: 5 ms
loop through enabled during
standby, view-mode
1 V +1/-2dB R 75 Ohm
pp out
1 V +3/-3dB R 75 Ohm
pp in
+/- 3 dB R 1 kOhm
rms out
0,2 V to 2V R 10 kOhm
rms rms in
500 mV +/- 3 dB R 1 kOhm
rms out
0,2 V to 2 V R 10 kOhm
rms rms in
low: 2 V (low) R 10 kOhm
in
high: 4.5 V (high) R 10 kOhm
in
loop through enabled during
standby, view-mode
1 V +1/-2dB R 75 Ohm
pp out
1 V +3/-3dB R 75 Ohm
pp in
VR120
Cinch Audio/Video input on front panel (OPTION)
Audio:
AINFR (audio right in) red 0.2 V
AINFL (audio left in) white 0.2 V
Input impedance 47 kOhm
Video:
VFR yellow
Input impedance
Cinch Audio Out Rear (OPTION)
AOUT1R (audio right out) red
AOUT1L (audio left out) white 500 mV
This outputs are in parallel with the corresponding outputs on
Euroconnector 1.
TUMOD
Modulator:
Frequency range loop through
Gain: ANT IN - TV OUT
ANT IN - TUN OUT
Switch for RF input attenuation
Frequency range out (tuned by IIC bus)
Tuner:
Frequency range
Input voltage max.
min.
1. GB 9
to 2 V typ. 500 mV
rms rms rms
to 2 V typ. 500 mV
rms rms rms
1 Vpp + 3 / -3 dB
75 Ohm
500 mV +/- 3 dB R 1 kOhm
rms out
+/- 3 dB R 1 kOhm
rms out
45 MHz - 860 MHz
2 dB + 3 / -2 dB
2 dB + 3 / -2 dB
NO
Ch 21 - Ch55
43 MHz - 860 MHz
for UK 450 MHz - 860MHz
< 100 dBµV
> 60 dBµV