Printer Section - JVC 0298MNV*SW*VP Instructions Manual

PRINTER SECTION

If
Picture data cannot
be transmitted
through the DV
connection
Picture blurred
when printed from
the camcorder with
the DV connector
Picture data cannot
be transmitted
through IrDA
reception
Check to see if
Printer is in DV mode.
Press IrDA/DV button to light the DV lamp.
Cable is in correct connection.
Make sure of proper connection.
Picture is recorded on the DV tape.
Use a tape with picture data recorded.
Camcorder with the DV connector is in Still
Picture mode.
When installing a picture from the camcorder by
the DV connector to the printer, set the camcorder
with the DV connector in Still Picture.
Printer is in IrDA mode.
Press IrDA/DV button to light the IrDA lamp.
Picture data is being transmitted at a correct
distance and angle.
Aim the transmitter right in front of the IrDA sensor
of printer and transmit within an approx. 50 cm
distance. Data communications may be difficult at
a too close or too remote distance depending on
the machines in use.
39
EN
Reference
pages
10
16
16
11
18