Sharp 13VT-R100 Service Manual page 41

Ë Test points layout of Main Unit.
ADJUSTMENT OF STILL PICTURE
VERTICAL SYNC
Measuring Monitor screen
instrument
Mode EP still picture playback
Input signal Self-recording tape
Test point Monitor screen
CH '/" (TR
Control
Specification No Vertical jitter
Figure 2-2.
1. Play back the EP Self-recorded tape in the still mode.
2. Using the CH '/" (TR
3. Then press the STOP button to stop the tape.
Note:
The data of this adjustment is memorized to the E
± / — ) buttons
IC.
41
±
control or on the front pannel, make adjustment so that
the vertical jitter becomes minimum.
13VT-R100/R150
13VT-CR10
/ — ) buttons on the remote
2
P-ROM