Panasonic KX-NS1000 Installation Manual page 179

5.
Confirm if the configuration file was successfully loaded.
a. Select Maintenance ® Export Configuration File.
b.
Click Export to download the configuration file being used currently on the SIP phone.
c.
Compare the UT_ACS.cfg file and the downloaded file. If the UT_ACS.cfg file was successfully loaded,
the contents of those 2 files will be exactly the same.
Notice
When the 2 UT_ACS.cfg files do not match, and if the SIP phone does not work properly, contact
an authorised Panasonic Factory Service Centre.
For Non-KX-UT Series SIP Phones
Using a DHCP server (DHCP Server feature or an external DHCP server) to automate the assignment
of IP addressing information
The IP address of the SIP phone, the subnet mask address, and the default gateway address can be assigned
to the SIP phone automatically by the DHCP server.
The PBX's IP address must be assigned manually on the SIP phone side.
For instructions, refer to the documentation of the SIP phone.
Not using a DHCP server (DHCP Server feature or an external DHCP server) when assigning IP
addressing information
All of the IP addressing information must be assigned manually.
For instructions, refer to the documentation of the SIP phone.
Note
•
A SIP phone can only receive IP addressing information from a DHCP server on its own LAN. Therefore,
when SIP phones are located on several LANs, a DHCP server is required on each LAN.
•
When the DHCP client function is enabled for SIP phones, simply connect them to the LAN to use the
DHCP server. For details about the DHCP client function setting, refer to the documentation of the SIP
phone.
5.8.1 Assigning IP Addressing Information
Installation Manual 179