Toshiba e-studio2040c Quick Start Manual page 45

Stapler Unit of Hanging Finisher (MJ-1031)
1
2
3
Push the lever to separate the Hanging Finisher
from the equipment, and then open the cover.

1
Take off the staple cartridge, and then take the
empty staple case out of the staple cartridge.

Install a new staple case into the staple cartridge.
Be careful not to catch your fingers between the equipment and the Finisher (optional).
This could injure you.
1
2
3
2
2
4
4
1
Press down the transparent cover and pull out the
seal.
5
Install the staple cartridge.

2
1
Close the Finisher cover, and then install the
Hanging Finisher to the equipment.
Replacing Staple Cartridge
2
2

4