Connecting Speakers - JVC 0303MWMMDWJEM Instructions Manual

AM antenna
1 2
ANTENNA
3
AM loop antenna
(supplied)
1
If the cords are covered with insulation, remove the
short section of insulation at the end of each cord by
twisting and pulling it off.
2
Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
3
Turn the AM loop antenna until you have the best
reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
The AM loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals or connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
9
AV
COMPU
LINK
Vinyl-covered wire
(not supplied)

Connecting Speakers

To connect speakers
You can connect the speakers using the speaker cords.
1
2
Speaker terminals
SPEAKERS
Red
RIGHT
Speaker
SPEAKER IMPEDANCE
cord 6~16Ω
Black
INPUT
Rear of the right
speaker
1
If the cords are covered with insulation, remove the
short section of insulation at the end of each cord by
twisting and pulling it off.
2
Hold the clamp of the speaker terminal.
3
Insert the end of the speaker cord into the terminal.
Match the polarity of the speaker terminals: (+) to (+)
and (–) to (–).
4
Release your finger from the clamp.
IMPORTANT:
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to one speaker
terminal.
3,4
Red
LEFT
Speaker
cord
Black
INPUT
Rear of the left
speaker