Precautions When Using The Adjustment Remote Commander - Sony CCD-TRV32 Service Manual

4) The adjustment remote controller is operated as follows:
• Changing the page
The pages increase when the EDIT SEARCH (+) button is
pressed and decrease when the EDIT SEARCH (–) button is
pressed. Altogether there are 16 pages from page "0" to page
"F".
Hexadecimal
0 1 2 3 4 5 6 7 8 9 A B C D E F
notation
LCD display
0 1 2 3 4 5 6 7 8 9 A b C d E F
Decimal
notation after 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
conversion
[Sequence of Service Models Using the Adjustment Remote
Commander]
START Normal mode
Set the NORM - ADJ (HOLD)
Enters the service mode
switch ADJ (ON)
Press the EDIT SEARCH
Page changed
+/- button
Press the FF/REW button Address changed
Press the PLAY/
Data changed
STOP button
Date stored
Press the PAUSE button
Set the NORM - ADJ (HOLD)
switch NOR (OFF)
Command Name Command Function
Page Up Page + 1
Page Down Page – 1
Direct Page Set Sets the specified page
Address Up Address + 1
Address Down Address – 1
Data Up Data + 1
Data Down Data – 1
Store Stores data in the EE PROM. Pause
2. Precautions when using the adjustment remote
commander
Mishandling of the adjustment remote commander may erase the
correct adjustment data which has already been stored in the memory.
To prevent this, it is recommended that all adjustment data is noted
down on the attached page F address list before starting adjustments
in addition to all new adjustment data after the completion of each
adjustment step.
• Changing the address
The address increases when the FF ()) button is pressed,
and decreases when the REW (0 ) button is pressed.
Altogether there are 256 addresses from address "00" to address
"FF". Some addresses, which are not used during adjustment,
do not appear.
• Taking note the already-stored adjustment data
The previous adjustment can be erased if the adjustment remote
commander is incorrectly handled. To prevent this, it is
recommended that all the stored adjustment data be noted down
on the attached page F address list.
• Changing the data (Data setting)
The data increases when the PLAY (() button is pressed,
and decreases when the STOP (p) button is pressed. Altogether
there 256 data from data "00" to data "FF".
• Storing the data
Press the PAUSE button to store the adjustment data (page F)
into the non-volatile memory.
(If the PAUSE button is not pressed after completing the
adjustment, the new adjustment data will not be stored in the
non-volatile memory.)
5) After completing all adjustments, turn off the main power
supply (7.2 V) once. This releases the adjustment mode (all
modes except for page F).
Refer to the memory map
Data stored in EE PROM
Normal LANC Command
Edit Search +
Edit Search –
Event Clear
Fast Forward
Rewind
Play Back
Stop
6-5
< When changing adjustment data >
The EVR value (RAM) is changed to the new data.
(But the changed data is not stored in the EE PROM.)