Bosch ICP-AMAX4-P1 Installation Manual page 147

AMAX panel 4000 / AMAX panel 4000
EN
Date and time is programmed and the fault is reset. Refer to System Setting, page 61 for more
information.
Supervise:
1.
2.
3.
6 - Communication Failure
–
Condition:
Panel cannot send the report to the Destination 1 after 4 attempts.
Restore:
The fault is reset when the first kissoff tone is received and fault is reset.
Supervise:
1.
2.
3.
7- Tamper
System Tamper
Onboard Tamper Condition is registered when the Onboard Tamper input is open.
Condition:
Onboard Panel Tamper input is open.
Restore:
The Tamper condition is reset when the Input is shorted and Tamper condition is reset.
Supervise:
1.
2.
3.
Keypad Tamper
Condition:
Keypad 1 is opened and the Tamper contact is triggered.
Restore:
The Tamper condition is reset when the Keypad is closed and Tamper condition is reset.
Supervise:
1.
2.
3.
Zone Expansion Module Tamper
Zone expansion module 1 to 6 tamper
Bosch Sicherheitssysteme GmbH
Report the date and time fault to the configured destination programmed on location
124.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators)
No report to the AMAX panel system, when date and time setting is recorded in
nonvolatile memory and AMAX Panel is reset. The FAULT indicator is turned off when
there is no other system fault.
Communication Fault 1 - 4
Report the fault to configured destination on address 124 when the fault is detected.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Report the Tamper condition to configured destination on Address 124 when the Tamper
Condition is detected.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
When the Tamper Condition is reset, send the restored report to the configured
destinations.
Report the Tamper condition to configured destination on Address 124 when the Tamper
Condition is detected.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
When the Tamper Condition is reset, send the restored report to the configured
destinations. The FAULT indicator is turned off when there is no other system fault.
Installation Guide
Troubleshooting | en 147
2014.4 | 01 | F.01U.267.112