Table of Contents
Advertisement
QQ
3 7 63 1515 0
Step 2 : Setting up the remote commander (continued)
Notes
¥ With normal use, the batteries should last about three to six months.
¥ If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
¥ Do not use a new battery together with an old one.
¥ Do not use different types of batteries together.
¥ Some buttons may not work with certain Sony TVs.
TE
L 13942296513
12
Getting Started
Step 3 : Connecting the VCR (continued)
Additional connections
To a TV that has audio/
video input jacks
This additional connection
improves picture and sound
quality. Connect the TV as
shown on the left.
To a stereo system
(SLV-ED949ME/SG
only)
You can improve sound
quality by connecting a
stereo system to the LINE
OUT AUDIO R/L jacks as
shown on the left.
Note
¥ To play a tape in stereo, you must connect your VCR either to a TV with audio/
video input jacks or to a stereo system as shown on above left.
www
.
Getting Started
14
http://www.xiaoyu163.com
For SLV-ED949ME/SG
LINE OUT
LINE IN
Audio/video cable (not supplied)
For SLV-ED343ME/SG
LINE OUT
LINE IN
Audio/video cable (not supplied)
LINE OUT
AUDIO R/L
LINE IN
Audio cable (not supplied)
x
ao
u163
y
i
http://www.xiaoyu163.com
2 9
8
Step 3 : Connecting the VCR
Connect the aerial to your VCR and TV as shown below to watch TV
programmes and VCR pictures on your TV. In addition, if your TV has
audio/video (A/V) input jacks, we recommend you connect the VCR to your
TV using an audio/video cable to get a better picture and sound.
Connecting the aerial
: Signal flow
1
Disconnect the aerial cable from your
TV and connect it to
panel of the VCR.
2
Connect
input of your TV using the supplied
aerial cable.
3
Connect the mains lead to the mains.
Note
¥ When you connect the VCR and your TV only with an aerial cable, you have to
tune your TV to the VCR (see page 15).
Q Q
3
6 7
1 3
1 5
Step 4 : Setting up the VCR with
the Auto Set Up function
Before using the VCR for the first time, set up the VCR using the Auto Set Up
function. With this function, you can set the language for the on-screen display and
TV channels automatically.
1
Turn on your TV and set it to the video channel.
Tune the TV to channel 32 (the initial RF channel for this VCR).
Refer to your TV manual for TV tuning instructions. If the picture
does not appear clearly, see To change the RF channel on
page 17.
2
Connect the mains lead to the mains.
The VCR automatically turns on.
PLAY
OK
The LANGUAGE SET menu
appears on the TV screen.
Press </, to select the desired
language, ENGLISH or ARABIC,
then press OK.
The message for the Auto Set Up
function appears.
co
.
1-3
9 4
2 8
Mains lead
AERIAL IN
to mains
Aerial cable (supplied)
on the rear
of the VCR and the aerial
0 5
8
2 9
9 4
2 8
Getting Started
E N G L I S H
A R A B I C
S E L E C T
:
S E T
:
O K
E X I T
m
Getting Started
9 9
continued
9 9
13
:
M E N U
continued
15
Hide quick links:
Advertisement
Table of Contents
