Sony VPL-DX10 Quick Reference Manual page 27

5
Insert the new lamp all the way in until it is
securely in place (a). Tighten the two
screws (b). Fold down the handle to
replace it (c).
Notes
• Be careful not to touch the glass surface of
the lamp and a inside conductor.
• Insert the handle firmly to attach it
securely.
• The power will not turn on if the lamp is not
secured properly.
6
Close the lamp cover and tighten the screw.
Note
Be sure to attach the lamp cover securely as it
was. If not, the projector cannot be turned on.
7
Turn the projector back over.
8
Connect the power cord.
?
The /1 key lights in red.
9
?/1
Press the key to turn the projector on.
10
Press the MENU key, and then select the
Setup menu.
11
Select "Lamp Timer Reset", and then press
the ENTER key.
Fold down
the handle.
"Settings for Lamp replacement. Has the
projection Lamp been replaced?" is
displayed in the menu screen.
12
Select "Yes" with the
press the ENTER key.
The Lamp Timer is initialized to 0, "Lamp
Timer Reset Complete!" is displayed in the
menu screen.
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be
regulated due to environmental
considerations. For disposal or recycling
information, please contact your local
authorities or the Electronic Industries
Alliance (www.eiae.org).
Lamp Timer Reset
Settings for Lamp replacement.
Has the projection Lamp been replaced?
Yes No
b
key, and then
Replacing the Lamp
11
GB