JVC TV 13142 User Manual page 43

5
Set the start time, end time, channel and tape
speed as in step 4.
ENTER
SET
SET
7
To set the timer for another program, press the
SET + or – button until the position of the
second program blinks, then press the ENTER
button. Repeat steps 4 to 6 to set the second
program.
•
NOTE: The VCR section cannot be used while the REC TIMER indicator is lit. If you want to use the VCR
operation, press the TIMER button to deactivate the timer.
•
After a power failure or disconnection of the power plug, all programmed recording setting and time
display will be lost upon resumption of power. In this case, reset the clock (see pages 14-16.) and
reprogram any timer recordings.
•
If you want to correct the digits while setting, press the CANCEL button until the item you want to
correct, then press the SET + or – button to correct the desired setting.
TIMER REC SET
DATE 23 (TUE)
7 : 00 PM
START
9 : 30 PM
END
CH 007
SPEED EP
+/—/ENTER/CANCEL/MENU
5
5 6
6
Press the ENTER button to accept them.
ENTER
8
Press the TIMER button. The REC TIMER
indicator will light. The Timer is programmed,
when the programmed time is reached, the
recording is automatically started.
TIMER
To cancel timer recording, press the button again and
REC TIMER indicator will go out.
23 TU 7:00 9:30 007
PM PM EP
----- --:-- --:-- --- -
----- --:-- --:-- --- -
----- --:-- --:-- --- -
----- --:-- --:-- --- -
----- --:-- --:-- --- -
----- --:-- --:-- --- -
----- --:-- --:-- --- -
+/—/ENTER/CANCEL/MENU
8
REC TIMER
41