Table of Contents
Advertisement
Adjusting the H PHASE
1
Press and hold the [MENU] button for about 3
seconds until the LCD display shows the menu display
Cursor
1: GENLOCK
2: CABLE
2
Ensure that the cursor ( ) is located on
1: GENLOCK , then press the control knob to display
1A: SD H PHASE or 1B: HD H PHASE
Item
1A: SD H PHASE
1B: HD H PHASE
3
Press the [SHUTTER] control knob to move the cursor
( ) to the currently set value, then turn the [SHUTTER]
control knob to adjust the H PHASE value
(HD: -1024 to 1023, SD: -128 to 127)
1A: SD H PHASE
1B: HD H PHASE
4
After the adjustment, press the control knob to move
the cursor ( ) back to 1: GENLOCK
Memo :
2
3
● Screens
and
differ according to the Video Format of
the camera.
Setting
0
0
Cursor
127
1023
Adjusting SC phase (Only for SD signal)*
*1 This function is unavailable when connected to GY-HM790
series.
1
Turn the [SHUTTER] control knob to display
1C: SC COARSE
1C: SC COARSE
2
Press the [SHUTTER] control knob to move the
cursor ( ) to the currently set value, then turn the
[SHUTTER] control knob to adjust the SC COARSE value
(to 0 , 90 , 180 or 270 )
1C: SC COARSE
3
After the coarse adjustment, press the [SHUTTER]
control knob to move the cursor ( ) back to 1C: SC
COARSE , then press the [SHUTTER] control knob to
display 1D: SC FINE
1D: SC FINE
4
Press the [SHUTTER] control knob to move the
cursor ( ) to the currently set value, then turn the
[SHUTTER] control knob to adjust the SC FINE value
(from -128 to 127)
1D: SC FINE
Memo :
● [SC COARSE] and [SC FINE] are linked. When the upper
or lower limit of [SC FINE] is exceeded, the value of [SC
COARSE] changes.
For example, when the value of [SC COARSE] is 0
[SC FINE] is increased, once [SC FINE] exceeds 127 ,
[SC COARSE] will become 90
become -128 .
5
After the adjustment, press the [MENU] button to
return to the previous display
STR
OFF
CMP
0 dB
6
Press the [BARS] button to stop the color bar signal
output
0
90
0
127
and
and [SC FINE] will
ALC
LUX
1
Advertisement
Table of Contents
