Transferring A Call After A Speaker Call Announcement In A Group; Sending A Trunk Flash - Siemens HiPath 2000 User Manual

Step by Step
Consultation?
*80=Speaker call?
Transfer?
*51=Trunk flash?
Transferring a call after a speaker call
announcement in a group
If this function has been configured (contact your ser-
vice personnel), you can use a speaker call (announce-
ment, page 85) to announce a call in progress to a
group of users
After a member of the group has accepted the call re-
quest, you can transfer the waiting party.
Prerequisite: You are conducting a call.
Confirm. The other party is placed on hold.
$
Press the key shown.
Select and confirm the option shown.
j
Enter the group's station number.
[
Announce the call.
When a member of the group accepts the call
page 39, you are connected to this party.
\
Replace the handset.
or
Select and confirm the option shown.
If the connection between the two other parties is
not established within 45 seconds, the call from
the first part returns to you (recall).

Sending a trunk flash

To activate ISDN-type services and features through the
network carrier's analog trunks or those of other com-
munications platforms (such as "consultation hold"), you
must send a signal to the trunks before dialing the ser-
vice code or telephone number.
Prerequisite: You have set up an external connection.
N
Press the key shown.
Select and confirm the option shown.
j
Enter the service code and/or telephone number.
Enhanced phone functions
page 48.
57