Test Mode Function - Sharp VE-CG30U Service Manual

5.TEST MODE FUNCTION

[Note]: The meaning of TEST MODE FUNCTION
1; Check and change EEPROM values, if required.
3; Check the version # of firmware.
How to enter the test mode (TEST MODE initial screen)
Reset the user mode settings first. Download the user mode settings reset program to the SD card to create a test mode
setting card. Regarding Test Mode Setting Program("Shce0009.dat" & "Shcu0009.dat"), please refer to Service
Information. Insert this SD card for resetting the user mode settings in the camera and turn on the power while pressing
shutter. Then, "do you vertion up?; Do: Push Shutter, No: Do Not" appears on the CGS display. Next press shutter to
set the factory mode setting. (If it is not mecessary to reset the user mode setting, turn off the power and remove the
SD card.) The message changes to "vertion up start", and "version up complete" appears soon. After checking that
the power has turned on, turn it off and remove the SD card. Now restting the default settings is finished.
Shutter
3X
OPTICAL ZOOM
DIGITAL STILL
Power Key
Set the camera to the factory mode in the following procedure.
1) Turn on the power by pressing the power key with the MENU key pressed down.
2) When entering the test mode, the screen on the right(TEST MODE initial screen)
MENU Key
How to enter each test mode
1) Press the or key to select the desired test mode.
Each time you press the
Test Nos. and the corresponding test items are as follows.
TEST NOS. Test item
TEST 0 EEPROM address change
TEST 1 LCD test pattern display
TEST 2 Default settings
TEST 3 White balance low color temp. adjustment
TEST 4 White balance high color temp. adjustment
TEST 5 CCD pixel defect correction
TEST 6 Not use in service
TEST 7 AF adjustment
TEST 8 Not use in service
TEST 9 Shutter timing adjustment (open side)
TEST A Shutter timing adjustment (close side)
TEST B Not use in service
TEST C Not use in service
TEST D Battery adjustment
TEST E Not use in service
TEST F Not use in service
2) If the desired test item is found, press the SET key to select it.
[Note]: When finishing the service works, the camera must be set USER MODE again. In order to set the camera back
to USER MODE, execute TEST 2 written as "User mode settings" on page 11.
Do You VersionUp?
Do : Push Shutter
No : Do Not
or key
MENU Key
or key, each test item is displayed.
Under this test mode, following things can be done.
2; Apply several tests and adjustments.
Version Up Complete
SET key
Display
0 CANGE E2PROM
1 TEST PATERN
2 SET SHIPPING
3 WB LOW TEMP
4 WB HIGH TEMP
5 DEFECT WHT BLK
6 DEFECT WHT BLK
7 FOCUS
8 CCD SENSITIVITY
9 SHUTTER OPEN
A SHUTTER CLOSE
B WB HIGH CALIB
C LCD POSITION
D BATTERY VOLTAGE
E WB LOW CALIB
F TEST F
9
VE-CG30U
VE-CG40U
TEST MODE initial screen
TEST MODE
BOOT VER xxxxx
IPL VER xxxxx
MAIN VER xxxxx
SUB VER xxxxx
USB SNUM xxxxxxxx
0 CHANGE E2PROM