Performing The Initial Power-On Settings; Tv Controls - Beko LCD panel Owner's Manual

6

Performing the initial power-on settings

6.1-TV controls

6.1.1-Temporary on/off (STAND-BY)
When you press the red POWER
button located on the upper right
POWER
hand side of your remote control
while your television is switched on,
the sound and the picture will go off.
In the stand-by mode, the power
indicator of your television will glow
brighter. To switch your television
back on, either press any numeric
button or PR+/PR- buttons.
Caution! If you are not going to use your
television for a long time, unplug its power
cable from the socket.
6.1.2-Channel Selection
You may select whichever program
number you would like by pressing
the PR+/PR- buttons located on
your television and your remote
control. To select the programs
that are above 9, you can use the
Numerical buttons. You may enter
the number of the programme
you would like to select using the
numerical buttons. For example,
to switch to the program number 12, press
respectively the numeric buttons 1 and 2 on
your remote control. You can perform the
program selection also from the Program
Table.
6.1.3-TV and AV Mode Selection
Press the AV button on your remote
control. SOURCE menu will be
displayed. Select TV or desired AV
mode from the Source menu with
Up/Down navigation buttons and
confirm with OK button so that your
television will switch to the source
you have selected.
6.1.4-Temporary sound mute (MUTE)
To temporarily mute the sound of
MUTE
your television, press the MUTE
button on your remote control. In
that case, MUTE symbol will appear
on the screen. When you press the
same button a second time, the
sound will be restored. If you press the VOL+
button while in the Mute mode, the sound
level is increased and the Mute function is
aborted.
6.1.5-Returning to Selected Program
(SWAP)
Allows you to switch between the
current program you watch and
the last selected program. For
example, if you change the channel
to Program 11 while you were watching
Program 1, press SWAP button to switch
back to Program 1. Press SWAP button to
switch back to Program 11 again.
6.1.6-Main Menu
Press the M button. The Menu including all
the setting menus will appear on the screen.
Navigate through the Menu titles with the Up
/ Down navigation buttons and press the
OK button to select the desired menu. If you
want to exit the menu in any step, just press
the EXIT button. Press
return to the previous Menu while you are in
a sub menu.
MAIN MENU
SOUND
PICTURE
PROGRAM TABLE
SETUP
FEATURES
9 I
EN
or M buttons to
o
SELECT
EXIT