Epson PowerLite 85 Installation Handbook

Epson PowerLite 85/825/826W

Cleaning the Air Filter and Vent

Your projector includes an air ter to ensure the best performance. If
dust collects on th
Dust clogs prevent proper ventilation and can cause overheating and
damage the projector.
If you see the following message, clean the air ter immediately.
The projector is overheating. Make sure nothing is blocking the
air vent, and clean or replace the air filter.
1. Turn the projector. Wait for the P power light to stop
then unplug the power cord.
2. To clean the intake vent and
designed for computers and other
have one, gently clean the vent with a soft brush (such as an
artist's paintbrush).
You can remove the air lter to clean both sides. For instructions,
see page 110.
The exhaust
vent is on the
other side of
the projector
3. If the dirt is di ult to remove or the
message appears again after cleaning, replace the lter as described
on page 110. Contact your dealer or call Epson at
800-GO-EPSON (800-463-7766) to purchase
or vent, clean them as described below.
use a small vacuum cleaner
e equipment. If you don't
is damaged, or if the
INSTALLATION HANDBOOK
note
To order replacement air
lters, request part number
V13H134A22. See page 13
for ordering information.
Maintenance
1