Siemens Hicom 150 H Operating Instructions Manual page 11

6WHS#E\#6WHS
(
Speaking to visitors via the entrance telephone:
Precondition: Your telephone rings.
Lift the handset within thirty seconds. You are connect-
ed to the entrance telephone immediately.
or
Lift the handset after more than thirty seconds.
Dial the entrance telephone number.
Opening the door from your telephone during a call
from the entrance telephone:
) Enter the code.
Dial the entrance telephone number.
Opening the door with a code (at the door):
After ringing the bell, enter the five-digit code (using the
keypad or a DTMF transmitter). Depending on how the
door opener has been programmed, a doorbell call
signal may or may not be forwarded.
Activating the door opener:
Lift the handset.
Enter the code.
Dial the entrance telephone number.
Enter the five-digit code. Default code = "00000"
(contact System Support).
or Enter the type of door opener. 1 = enable with ring,
2 = enable w/o ring = You can also open the door with-
out a doorbell ring.
Deactivating the door opener:
Lift the handset.
Enter the code.
Dial the entrance telephone number.
Special features must be taken into consider-
ation if your telephone operates with HiPath
AllServe 150 V1.0 (system networking via PC net-
work) Æ page 49!
0DNLQJ#DQG#$QVZHULQJ#&DOOV
44