Sony MZ-E800 Service Manual page 8

FRONT PANEL SECTION
Note on installation front panel section:
When mounting, shift S806, S807, and S808 in
the arrow B direction, then shift the knobs (AVLS),
(BASS BOOST), and (HOLD) in the arrow C direction so
as to adjust each knob and switch position.
Note: Claws (4 pcs) are very fragile
and require careful handling.
two claws
4 front panel section
knob (BASS BOOST)
SHUTTER SECTION
• LCD flexible board mounting method.
Meeting with the screw holes (2 pcs) and claws (4 pcs),
mount the LCD flexible board and bend it into S shape
before the connector (CN801), and then fix with the sheet
(flexible) as shown in the figure.
sheet (flexible)
4 sheet (FPC), adhesive
Note: Do not apply an
excessive force when
removing an adhesive
sheet (FPC) from the
bracket (FPC).
2 LCD flexible board
1 Open the shutter block
assy in the direction
of arrow A .
3 boss
2 convex portion
of screw hole
C
knob (AVLS)
knob (HOLD)
screw
(CN801)
7 shutter section
A
B
S806
S808
S807
two claws
• Torsion spring mounting method.
Mount the torsion spring on the bracket (A),
and hook the part
and then hook the part
as shown in the figure.
bracket (A)
6 screw, step
5 spring, torsion
bracket (FPC)
1 sheet (flexible)
– 8 –
3 boss
2 convex portion of screw hole
knob (HOLD)
knob (AVLS)
knob (BASS BOOST)
to the shutter leg,
a
to the bracket (A)
b
b
a
spring, torsion
3 four claws
6 screw, step