Table of Contents
Advertisement
4
4-16 Performing Setup from the Control Panel
Exit Setup
Server Setup
Network Setup
Printer Setup
Setup
Exit Network Setup
Port Setup
Protocol Setup
Service Setup
Network Setup
Jobs Saved in Printed Queue
1-99 [10]
This option appears only if Enable Printed Queue is set to Yes. Specify the number of
jobs to be stored in the Printed queue. Jobs in the Printed queue take up space on the
ColorPASS hard disk drive. If disk space is low, use a smaller value for saved jobs.
Clear Each Scan Job
After 1 day/Now/Manually/After 1 week [After 1 day]
Specify how you want to remove scanned data from the hard disk drive. If you select
Manually, the scanned data remains on the hard disk drive until specifically deleted, or
until all scanned jobs are cleared by the Administrator.
Save Changes
Yes/No [Yes]
Select Yes to activate any changes made in the Server Setup; select No to return to the
main Setup menu without making any changes.
Network Setup options
When you perform network Setup, you configure the ColorPASS to receive print jobs
over the network systems that are used at your site.
In the Setup menu, choose Network Setup, where you specify network addresses and
names to be used by workstations, servers, and the ColorPASS when they
communicate with each other.
The Network Setup menu includes three submenus that allow you to choose port
types, protocols, and network services. You must perform Port Setup and enable at
least one port.
For each item you enable, you are prompted to enter settings for that item.
Default values, where applicable, appear in this manual with square brackets.
You should display and select options only for the network systems that are currently
used at your site. If your network requirements change, you can change Network
Setup at any time.
Advertisement
Table of Contents
