Installing Batteries In Remote Control - Motorola Digital Consumer Terminal DCT1800 Installation Manual

Installing Batteries in Remote Control

Before using the remote control, you must install two AA (1.5 V) alkaline batteries. Figure 2-4
illustrates battery access on the back of the remote control.
To install batteries in a Motorola universal remote control:
1
Press and slide the battery compartment cover off.
2
Place the batteries in the compartment; be careful to observe the correct polarity.
3
Slide the battery compartment cover back into place.
Battery installation will vary with each style of remote control. Refer to the instructions included
with your remote control for installing batteries.
Figure 2-4
Back view of remote control
NOTE!
Use and dispose of batteries in accordance with all applicable laws, rules and regulations. Motorola will not be liable to
anyone for the user's failure to use and/or dispose of batteries in the proper manner and in accordance with such laws,
rules and regulations, or for any defect contained in batteries that may cause injury damage to persons or property.
+
+
Overview 2-5
DCT1800 Installation Manual