Miele KM 3034 Operating And Installation Instructions page 35

Problem
The burner does not
ignite when the cooktop
is being used for the first
time or after a long
period of not being
used.
The burner does not
ignite after several
attempts.
The power supply is
interrupted during
operation.
The gas flame goes out
after being lit.
The shape and colour of
the flame have changed.
The gas flame goes out
during operation.
The in-operation /
residual heat indicator
light is flashing.
Possible cause
There could be air in the gas pipe.
The burner is not correctly
assembled.
The gas supply tap is turned off.
The burner is wet and/or dirty.
The flame slits are blocked and/or
wet.
The flames aren't touching the
ignition safety device and therefore
it is not heating up enough:
- The burner components aren't
correctly in position.
- The ignition safety device is dirty.
The burner components aren't
correctly in position.
The burner head or burner cap
holes are dirty.
The burner components aren't
correctly in position.
Power outage
Power outage
Problem solving guide
Remedy
You may need to make several
attempts before the burner ignites
successfully.
Turn all control knobs to "ß" and
interrupt the power supply to the
appliance for a few seconds.
Assemble the burner correctly.
Open the gas supply tap.
Clean and dry the burner.
Clean and dry the flame slits.
Turn all the control knobs clockwise
to position "ß". If power has been
restored, the appliance can be
operated as normal.
Ensure the burner components are
correctly assembled.
Remove any soiling.
Ensure the burner components are
correctly assembled.
Remove any soiling.
Ensure the burner components are
correctly assembled.
Turn all the control knobs clockwise
to position "ß". If power has been
restored, the appliance can be
operated as normal.
Turn all the control knobs clockwise
to position "ß". If power has been
restored, the appliance can be
operated as normal.
35