Makita BTD146 Technical Information page 10

W
iring diagram
Fig.D-6 (Specifications with Line filter)
Brush holder
complete
After passing Lead wires through
Line filer, put the line filter here.
Do not put any Lead wires
on Seal.
Fig.D-7 (Specifications without Line filter)
Tilt Insulated terminals on
Lead wires' ends to 20°
from the vertical line
on the machine.
Brush holder
complete
Do not put any Lead wires
on Seal.
Line filter
Seal
Connectors
20°
Seal
Switch
Sponge A
Receive the tube for Lead wires
with the groove of Sponge A.
Lead wire holders
Lead wires connected to each connector
have to be fixed into Lead wire holders.
Switch
Sponge A
Receive the tube for Lead wires
with the groove of Sponge A.
Lead wire holders
Lead wires connected to each connector
have to be fixed into Lead wire holders.
LED job light
LED job light
P 10/ 11